![background image](http://html1.mh-extra.com/html/icp-das-usa/isagraf-pac-series/isagraf-pac-series_getting-started_3826573038.webp)
3-18
Getting Started:
PAC-5007/5107/5207/5307 Ver. 1.1, 12/2011 ICP DAS
Step 2: Set I/O module to the initial state
Every new module has the factory default settings (as figure 1) for user’s convenient use.
If you use an old one and you don’t know the configuration of the module, please set
the I/O module to the initial state (as figure 2).
The Factory Default Settings :
I/O Module
I-7000
M-7000
I-87K
Address
1
1
1
Baud rate
9600
9600
115200
Checksum
Disabled
Not defined
Disabled
Protocol
DCON Protocol
Modbus Protocol
DCON Protocol
The Initial Settings:
I/O Module
7000 Series
(I-7000 & M-7000)
I-87K Series
Address
0
0
Baud rate
9600
115200
Checksum
Disabled
Disabled
Protocol
DCON Protocol
DCON Protocol
HOWTO: Initialize the I/O module
*I-7000:
To set I-7000 module to the initial state, please wire the INIT* to GND (if there is a DIP
switch on the back of it, just set the switch to “INIT” position) and power on the module.
Then the module will become initial state.
*I-87K:
To set I-87K module to the initial state, please set the related DIP Switch on the
I-87K4/5/8/9 I/O expansion unit. For example, change DIP-1 to “ON” and restart the
power, the I/O module in the first slot will become initial state.
Note:
If you use I-87K
9
or I-87K
5
I/O expansion unit, the
DIP-1 is corresponding to the second
slot, so do not use the first slot.
Following, we would like to use I-87K I/O module as an example to show how to serch and
configure with DCON Utility.