Configuring and managing the IGW3000
20
depending on the device. For more information on how to determine this address, please
refer to your device manual.
• Enabled: select this check box to include the device in the current access list. To
temporarily exclude the device from the access list, deselect it.
• Clear: use this button if you want to permanently remove the device from the access list.
6.
When you are finished editing your access list entries, click the Save button to save your
changes.
After applying these settings with the Apply button, the access list configuration will be changed.
Note
The maximum of allowed connected clients is 255.
Network scanning
The network scan tool enables the IGW to execute a site survey for all wireless networks in the
neighborhood. As a result of this survey, a list of scanned networks is presented. In order to
execute the site survey from your IGW, complete the following steps:
1.
Click Wifi > Network Scan to open the Network Scan tab.
Figure 14. Network Scan tab in the Wifi menu
2.
Press the Scan button in the top-right corner of the Network Scan tab.
3.
Wait for the site survey to complete. This might take up to 10 seconds and temporarily disrupt
all Wi-Fi communication.
4.
When the site survey completes, the table of networks will display, including the following
information:
• SSID: the SSID of the neighboring network.
• BSSID: the BSSID of the neighboring network.
• Channel: the operating channel number of the neighboring network.
• Quality [%]: percentage signal quality of the neighboring network.
• Rate [Mbit/s]: transmission rate of the neighboring network in Mbits/s.
• Encryption: encryption type and method used by the neighboring network.
5.
If you would like to refresh the table, press the Scan button again.
