Page
7
USER MANUAL FOR iCOOL RECOVERY SYSTEMS
MODEL C COMPACT MODELS 2009-2010 Updated Oct 2010.
Updates are published regularly on our website www.icoolsport.com
The
MAiN OPERATiNG SCREEN
provides many options which are covered elsewhere in this manual, however
to quickly start the system you can simply accept the default water temperature setting of 15ºC or touch the
ChANGE SETTiNGS
button to select a different temperature. 10ºC will be inserted automatically but you can
change to any temperature you require.
The temperatures can
also be displayed in Fahrenheit. This is explained later in this
Manual.
Simply touch the up and down arrow buttons and the desired
pool water temperature will appear on the bottom left-hand of
the screen in the blue window marked “SELECTED TEMPERA-
TURE”. The right-hand side of the screen shows the outside air
temperature.
Once the pool water temperature you want your iCool to cool to
is showing, touch the
START
button. This takes you back to the
main run screen which is the screen that you will use most of the
time during normal operation.
STEP 5
Touch the
START
PUMP
button. This will start the pump operat-
ing and water should begin circulating.
NOTE! When you touch
START buttons they change to STOP buttons and can then be
used to STOP that function if required.
iT iS ESSENTiAL ThAT ThE WATER iS FLOWiNG CORRECTLY
BEFORE YOU TOUCh ThE
START SYSTEM
BUTTON.
The water flow is pre set to an optimum flow of about 15-20 litres
or around 3-5 gallons per minute. This allows time for the heat
exchanger to operate at maximum cooling efficiency.
Pool water is completely changed approximately every 15 to 20
minutes.
Do not touch the
START SYSTEM
button until you are sure that
water is flowing smoothly. if water does not flow smoothly within a minute, please check that the hose from the
bottom of the pool is flat on the floor and no part of it is higher than the top of the water. Check that the water
in the pool is higher than the inlet connectors on the iCool. if this does not correct the problem the system will
sound an alarm and a red warning screen will appear with information about how to correct the water flow prob-
lem.
STEP 6
Now that you have pre set your desired temperature and started the circulating pump, the touch screen should
look like the picture at the top of this page. (of course the temperatures may be different). Notice that the pump
button will have changed from
START
to
STOP
. You can use this same button to start and stop the pump at any
time.
Now, touch the
START SYSTEM
button and the cooling cycle will begin. The water will be cooled to your preset
temperature and the system will then cycle to maintain it at that temperature automatically.
The SYSTEM can
only be started once within any 3 minute period to avoid overloading the compressor. if you don’t hear it start do
not touch the START SYSTEM again , it will start automatically after the 3 minutes safety period elapses.
if your iCool is the
CONTRAST MODEL
then, depending on the temperature you set, it will either heat or cool the
water automatically to reach your preset temperature and then maintain it at that temperature. More detailed
information about the operation of the
CONTRAST
version can be found later in this manual.
FOR ThE SAFETY OF USERS, YOU CAN NOT SET TEMPERATURES BELOW 5°C OR ABOVE 45°C
. (
40°F-112°F)
iN AN EMERGENCY YOU CAN STOP ALL FUNCTiONS iMMEDiATELY BY TOUChiNG ThE “ALL STOP” BUTTON
however, if the cabinet is hot, the fan may continue to run until the cabinet has cooled.
WATER TEMPERATURE SETTiNG SCREEN
START
START
START
START
START
START
10
22
22
30
15
24
MAiN OPERATiNG SCREEN
