icontrols PULSE, Руководство по установке и инструкции пользователя

Страница: 6 / 30

6
7
Right Hand Mounting:
The software and hardware must be modified for right-hand side mounting.
Refer to “OPERATOR START-UP/SET-UP, MOTOR POSITION.
Field Adjustment of the Encoder for Right-Hand Mounting:
Instructions to adjust the hardware for right hand
mounting: See Fig: 3.
Remove the 4 bolts, spacers that secure the
encoder on the left-side of the gearbox and set
the encoder mounting plate, bolts and spacers
aside.
Remove the cable tie that secures the cable to
the gearbox.
DO NOT ATTEMPT TO REMOVE/
DISCONNECT CABLE!
Insert a long screwdriver through the hollow shaft
from the right side of the gearbox and gently tap
out the encoder magnet assembly wedged in
the left side of the gearbox hollow shaft.
Align the key and insert the magnet assembly
into the right side of the hollow shaft and gently tap with a rubber mallet until it is slightly
recessed 1 mm (1/32”) in the hollow shaft (level with the inner bevel edge of the hollow shaft).
ENSURE THAT THE MAGNET IS VISIBLE AND FACING OUTWARDS FIG: 3 PRIOR TO INSERTION.
Attach the encoder mounting plate to right-side of the gearbox, so that it covers the encoder
magnet assembly, ensuring that the cable is facing towards the bottom of the operator, use
existing bolts and spacers. Ensure that bolts are fully
tightened. DO NOT TWIST THE CABLE.
Please note that the face of the encoder should not
be more than 1mm (1/32”) from the magnet. If too
far, the encoder may not detect the magnet. If too
close, friction will lead to limit retention issues.
Assembling Torque Arm to Gearbox
The torque arm must be assembled onto the gearbox
on the opposite side of encoder using the enclosed
4 bolts. There are 6 possible positions for the torque
arm, and its optimal mounting position should be
pre-determined prior to assembly. Tighten bolts
appropriately. THE TORQUE ARM IS AN INTRINSIC
COMPONENT OF THE OPERATOR’S SAFETY AND
FUNCTIONALITY AND MUST BE INSTALLED SECURELY. See
Fig: 4
See Fig; 4A-F For recommendations on how
to mount Torque Arm to Operator/Mounting
Bracket in relation to Shaft Off-set.
FIGURE: 3
FIGURE: 4
Magnet on
this side
Encoder