ICONICO WC 2, Инструкция по установке и эксплуатации

Страница: 23 / 34

23
Installation and user manual WC2
Manual flush
Flushing during a black out
More humanized design
1. Short press the flush button on the remote
2. Short press the flush button on the toilet lever
3. Gently kick the right side of the toilet, near the sticker.
In the event of a blackout, you can still flush the toilet if the water source is available and
the batteries are in good condition.
• Damping slowing down.
The product adds a damping function to make the seat fall
slowly with a simple push.
• Water purification
The filter device purifies the water source to ensure the clean
and hygiene when using.
• Auto power-off
The product will close after stand by for 36 hours to avoid
wasting and concern.
Flush time adjust
First you will adjust the flushing valve, the light surrounding the main button of the side
lever, will blink with green color at 0,5s intervals. Use the remote control [gear po]
and the [Gear position -] to adjust the time, adding or substracting 0.5s with every click.
The adjustment range is 4-10 seconds. Once you reach the desired flush time, pull the lever
down.
Now you have entered the exhaust valve adjustment, the orbital light of the main button will
turn yellow. Follow the same procedure than before to add or reduce the time.
Once you flip down the side lever to end the second setting, you will enter the third setting,
corresponding to the set the water return time, the orbital light will now be red, until you
finish the process following the same procedures, ending by flipping down the side lever.
Once the time setting reaches it's maximum value, you will hear a tone of failure. The
respective default time for each one of the 3 valves is 5s, 6s, 7s, and all the adjustment
ranges go from 4 to 10 seconds.
Press and hold the side flush button or hold down the side lever for 8s to enter into the
flushing time adjustment function and adjust the pulse valve time.