ICONICO WC 2, Инструкция по установке и эксплуатации

Страница: 12 / 34

12
www.iconico.es
4.3.2 Connect to water supply pipe
1. Disassemble the old water supply angle valve and install the water supply angle valve
supplied with the toilet.
Close the main angle valve before disassembling.
2. Install the angle valve filter and the decorative cover of the angle valve to the proper
position, then open the angle valve to drain for 1 minute until the water looks clean (use a
container for the water that will go out).
3. Connect the angle valve filter, water supply hose and pre-filter in sequence as shown in the
below picture.
1. Connect the smaller water hose to
the filter and tighten it with a wrench
or a span.
2. Connect the larger water supply
hose to the filter and tighten the nut.
3. lnstall the filter to the angle valve
and tighten it with a wrench or a span
4. The installation is finished.
Filter
Filter
Filter
Angle valve
Angle valve
Filter
Nut
Water supply hose
Water supply hose