BIA-DPC3 rev 5
Page 18
2.0
GENERAL
2.1 Electrical connection to the power supply and pump
DANGER. Electric shock risk.
Before carrying out any installation or maintenance operation, the control panel should be disconnected from the
power supply and one should wait at least 2 minutes before opening the control panel.
Never connect AC power to output U1 V1 W1 terminals.
Ensure the motor, controller and power specifications match.
The electrical and hydraulic connections must be carried out by competent, skilled, qualified personnel.
Other terminals.
Terminals 7 and 8
MODBUS communication to Slave Controller or BMS
Terminals 15 and 16
N.O. close on fault
Terminals 9 and 11 and 10 and 12 for connection to motor thermal protection (microtherms) where available. If not
available leave jumper wires in.
Main Circuit Breaker
Содержание DPC3
