SUPPLEMENTS / FAA EXEMPTION
9-18
CHANGE A3
ICON A5 / PILOT’S OPERATING HANDBOOK
CH
AP
TER 9
3
61.415, 61.429(b), and 65.107(b) and (c) of Title 14, Code of Federal Regulations (14 CFR)
to the extent necessary to allow:
x
ICON A5 aircraft with a maximum takeoff weight (MTOW) of 1,680 pounds to be
eligible for issuance of a special airworthiness certificate in the light-sport category.
x
Persons exercising the privileges of a sport pilot certificate or student pilots seeking a
sport pilot certificate to operate the ICON A5 and to permit flight time obtained in the
ICON A5 to be considered flight time obtained in a light-sport aircraft.
x
Persons exercising the privileges of a flight instructor certificate with a sport pilot
rating to provide flight training in the ICON A5.
x
Holders of sport pilot certificates and repairman certificates (light-sport aircraft) with a
maintenance rating or an inspection rating to perform maintenance and preventive
maintenance on ICON A5 aircraft as authorized within those sections.
This grant of exemption is subject to the following conditions and limitations.
Conditions and Limitations
1. This exemption applies to the ICON Aircraft model number A5, serial numbers
00001 – 99999.
2. ICON may issue the manufacturer’s statement of compliance required by
14 CFR § 21.190(b)(1)(iii) for its model A5 aircraft indicating a maximum takeoff
weight (MTOW) of up to 1,680 pounds (762 kilograms), provided the aircraft
meets all applicable requirements of 14 CFR § 21.190 and the conditions and
limitations specified in this exemption.
3. ICON must supply each purchaser of an ICON A5 certificated under the
provisions of this exemption with a copy of the exemption. A copy of this
exemption must be carried on board each aircraft during its operation.
4. The manufacturer’s statement of compliance required by 14 CFR §
21.190(b)(1)(iii) must:
(a) State that the aircraft meets the provisions of the applicable consensus standard
and the design requirements specified in these conditions and limitations.
(b) State that the aircraft meets the spin resistance standards of 14 CFR §
23.221(a)(2) without exceeding the pilot force limits of ASTM F2245 for
temporary application.
(c) State that the following safety design features have been incorporated into the
aircraft:
Содержание A5
