background image

INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR

If you purchase the optional chest pulse sensor (refer to page 20), follow the steps below to install the receiver
and the jumper wire included with the chest pulse sensor.

1. Remove the four indicated screws from the back of the

Console (5). Lift off the front of the Console. 

2. Plug the jumper wire (A) into the indicated jack on the

Console (5). Connect the other end of the jumper wire
to the wire on the receiver (B). Note: Any other wires
included with the chest pulse sensor can be discarded.

Next, peel the paper off the adhesive pad on the back
of the receiver (B). Orient the receiver as shown, and
press it onto the Console (5) in the indicated location. 

Refer to step 1 above. Reattach the front of the
Console (5) with the four screws. Make sure that no
wires are pinched.

17

8

9. Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may

be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical crosstrainer.

HOW TO CONNECT YOUR COMPUTER

Note: If your computer has a 3.5mm LINE OUT
jack, see instruction A. If your computer has only a
PHONES jack, see instruction B.

A. Plug one end of the audio cable into the jack

beneath the console. Plug the other end of the
audio cable into the LINE OUT jack on your com-
puter.

B. Plug one end of the audio cable into the jack

beneath the console. Plug the other end of the
audio cable into the splitter. Plug the splitter into the
PHONES jack on your computer. Plug your head-
phones or speakers into the other side of the splitter.

HOW TO CONNECT YOUR VCR

Note: If your VCR has an unused AUDIO OUT jack,
see instruction A below. If the AUDIO OUT jack is
being used, see instruction B. If you have a TV
with a built-in VCR, see instruction B. If your VCR
is connected to your home stereo, see HOW TO
CONNECT YOUR HOME STEREO on page 16.

A. Plug one end of the audio cable into the jack

beneath the console. Plug the other end of the
audio cable into the adapter. Plug the adapter into
the AUDIO OUT jack on your VCR. 

B. Plug one end of the audio cable into the jack

beneath the console. Plug the other end of the
audio cable into the adapter. Plug the adapter into
an RCA Y-adaptor (available at electronics stores).
Next, remove the wire that is currently plugged into
the AUDIO OUT jack on your VCR and plug the
wire into the unused side of the Y-adaptor. Plug the
Y-adaptor into the AUDIO OUT jack on your VCR. 

LINE OUT

Audio
Cable

A

PHONES

Audio
Cable

B

Splitter

Headphones/Speakers

AUDIO OUT

RIGHT

LEFT

VIDEO  AUDIO

ANT. IN

RF OUT

IN

OUT

CH

3

4

Audio Cable

Adapter

A

VIDEO  AUDIO

ANT. IN

RF OUT

IN

OUT

CH

3

4

Audio Cable

Adapter

B

Wire removed from

AUDIO OUT jack

RCA

Y-adaptor

8

20

15

14 38

13

8. Identify the Left Pedal (13). Attach the Left Pedal to the

left Flex Bar (14) with an Adjustment Bolt (20), an M10
Washer (38), and an Adjustment Knob (15) as shown.
Note: The Left Pedal can be attached in any of five
positions (see HOW TO ADJUST THE PEDALS on
page 9).

Attach the Right Pedal (not shown) in the same way.
Make sure that both Pedals are in the same position.

B

5

Jack

5

Lift

Here

1

A

Cylinder

2

Short

Screws

Long

Screws

Содержание PFEVEL39012













Отзывы: