27
MAINTENANCE
Regular maintenance is important for optimal per-
formance and to reduce wear. Inspect and properly
tighten all parts each time the rower is used. Replace
any worn parts immediately. Use only manufacturer-
supplied parts.
To clean the rower, use a damp cloth and a small
amount of mild detergent. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
RAIL MAINTENANCE
Regularly clean the rollers beneath the seat and the
area of the rail over which the rollers move. First,
see assembly steps 13 and 12 on page 12 and remove
the Rail Cap (74) and the Rear Stops (16, 17). Next,
roll the seat off the rail. Then, use a damp cloth and
a small amount of mild detergent to remove dust and
debris from the rollers and from the rail. Then, reattach
the parts that you removed.
TROUBLESHOOTING
Some problems can be
solved with the simple
steps in this section.
Find the symptom that
applies, and follow the
steps listed. If further
assistance is needed,
go to my.iFIT.com, scan
the QR code at the right,
or call 1-833-680-IFIT
(1-833-680-4348).
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power adapter is fully plugged in.
If you are having problems connecting the console to
a wireless network, or if you are having problems with
your iFIT account or iFIT workouts, go to my.iFIT.com.
If a replacement power adapter is needed, see
the Member Care contact information at the left.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
If the console does
not boot up prop-
erly, or if the console
freezes and does not
respond, reset the
console to the fac-
tory default settings.
IMPORTANT: Doing
this will erase all
custom settings you
have made to the
console. Resetting
the console requires
two people. First, unplug the power adapter. Next,
locate the small reset opening (A) on the right side of
the console. Using a bent paper clip, press and hold
the reset button inside of the opening, and have a
second person plug in the power adapter. Continue
holding the reset button until the console turns on.
When the reset operation is complete, the console will
turn off and then turn back on. If it does not, unplug the
power adapter and then plug it back in. Once the con-
sole turns on, check for firmware updates (see HOW
TO CHANGE CONSOLE SETTINGS on page 23).
Note: It may take up to a few minutes for the con-
sole to be ready for use.
A
MAINTENANCE AND TROUBLESHOOTING
Содержание NordicTrack RW600
Страница 4: ...UTS 4...