41
10
PAGER/CODE SQUELCH
10
• PERSONAL CALLS
This display appears when you are called with your ID code
and the calling station’s ID code is 123.
• GROUP CALLS
This display appears when you are called with the group
code, 888, and 888 has been programmed into code channel
C6.
• ERROR INFORMATION
When the transceiver receives an incomplete code, “E” and
previously received code appear.
■
Code squelch
When using code squelch you will only receive calls from sta-
tions which know your ID or group code. A 3-digit code is sent
each time [PTT] is pushed in order to open the receiving sta-
tion’s code squelch prior to voice transmission.
q
Set the operating frequency.
• Set the volume and squelch to the desired level as in normal op-
eration.
w
Push [A•
FUNC
], then push [0•
OPT
].
• Rotate [VOL] to select “dtm.CS,” if “dtm.PG” or “dtm.OF” ap-
pears.
e
Select the desired transmit code channel:
➥
Push and hold [0•
OPT
] for 1 sec. to enter code selection
mode.
➥
Rotate [VOL] to select the desired code channel.
➥
Push [
✱
•
ENT
] to exit code selection mode and return
to previous mode.
• 100 MHz digit shows “C.”
r
Operate the transceiver in the normal way (push [PTT] to
transmit; release [PTT] to receive).
t
To cancel the code squelch, push [A•
FUNC
] and [0•
OPT
],
then rotate [VOL] to select “dtm.OF.”
• 100 MHz digit shows “1” for IC-V82 or “4” for IC-U82 when the
function is cancelled.
Previously received code.
Code channel
“CP” and “ ” blink.
During channel number indication (described on page 16)
To use these functions in channel number indication, the
pager/code squelch setting must be programmed with other
memory contents before selecting channel number indication.
