33
8
SCAN OPERATION
8
D
Memory scan watch
While operating on a VFO frequency, memory scan watch
monitors for signals in each memory channel in sequence,
every 5 sec.
q
Push [C•
MR
] to select memory mode, if necessary.
• “
X
” appears.
w
Push [A•
FUNC
], then push [5•
SCAN
] to start the memory
scan.
e
Push [A•
FUNC
], then push [7•
PRIO
] to start the watching.
• VFO is displayed, then the decimal point “.”, on the frequency
readout blinks.
• When the signal is detected on the priority channel, the watching
is suspended according to the setting of the scan resume condi-
tion.
r
Push [D•
CLR
] to stop the watching.
■
Scan resume condition
When a signal is received during scanning, the scan resume
condition determines what action the transceiver takes. The
transceiver has 2 scan resume conditions available as
illustrated below. Use
SET MODE
to select the one which best
suits your needs.
q
Push [A•
FUNC
], then push [8•
SET
] to enter
SET MODE
.
w
Push [
Y
Y
] or [
Z
Z
] several times until “SCP” or “SCt” ap-
pears.
e
Rotate [VOL] to select the desired scan resume condition.
• Pause scan:
When receiving a signal, scan pauses on
the signal until it disappears. Resumes
2 sec. after the signal disappears.
• Timer scan:
When receiving a signal, scan pauses on
the signal for 5 sec., 10 sec. or 15 sec.,
then resumes.
r
Push [
✱
•
ENT
] (or [D•
CLR
]) to set and exit
SET MODE
.
Timer scan
Pause scan
USING
SET MODE
SKIP
Mch 1
Mch 2
Mch 3
Mch 4
Mch 5
Mch 199
Mch 6
Priority channel
Memory
scan
5 sec.
50 msec.
VFO frequency
