Icom IC-R5, Инструкция по эксплуатации

Страница: 38 / 80

27
6
SCAN OPERATION
New2001
■
Scan edges programming
Scan edges can be programmed in the same manner as
memory channels. Scan edges are programmed into scan
edges, 00A/00B to 24A/24B, in memory channels.
q
Push [V/M•S.MW•
~
] to select VFO mode.
w
Set the desired frequency:
➥
Select the desired band with [BAND• ].
➥
Set the desired frequency with [DIAL].
➥
Set other data
(e.g. offset frequency, duplex direction, tone
squelch, etc.)
, if desired.
e
Push [V/M•S.MW•
~
] for 1 sec. to select select memory
write condition.
• 1 short and 1 long beeps sound.
• “
” indicator and memory channel number blink.
r
Rotate [DIAL] to select the desired programmed scan edge
channel from 00A to 24A.
t
Push [V/M•S.MW•
~
] for 1 sec.
• 3 beeps sound
• The other scan edge channel “B,” 00B to 24B, automatically se-
lected when continuing to push [V/M•S.MW•
~
] after program-
ming.
y
To program a frequency for the other pair of scan edges,
00B or 24B, repeat steps
w
and
r
.
• If the same frequency is programmed into a pair of scan edges,
programmed scan will not function.
[V/M•S.MW•
~
]
[DIAL]
[EXAMPLE]: Programming 145.300 MHz into scan edges 03A.
FM SKIP P FM FM SKIP P FM SKIP P
Push for 1 sec. Push for 1 sec. Rotate
IC-R5_1.qxd 02.10.23 11:29 Page 27 (1,1)