Icom IC-M94DE, Инструкция по эксплуатации

Страница: 83 / 88

74
15
14
18
16
17
1
7
4
10
2
8
13
5
11
3
9
6
12
15
TROUBLESHOOTING
The transceiver does not turn ON.
z
The battery is exhausted or over discharged.
→ Recharge the battery pack. (p. 10)
z
The battery pack is not correctly attached.
→ Correctly reattach the battery pack. (p. 3)
Little or no sound comes from the speaker.
z
Squelch level is set too high.
→ Adjust the squelch level. (p. 15)
z
Volume level is set too low.
→ Adjust the volume level.
z
The speaker has been exposed to water.
→ Use the AquaQuake Water Draining function to remove water from the speaker grill.
(p. 18)
You cannot transmit, or cannot select high power.
z
Some channels are set for low power or receive only by regulations.
→ Change channels. (p. 13)
z
The output power is set to low.
→ Push to select high power. (p. 7)
z
The battery is exhausted.
→ Recharge the battery pack.
z
The battery is overcharged.
→ Confirm that the battery voltage is correct.
Scan does not start.
z
More than 2 favorite channels are not set.
→ Set the Favorite channels. (p. 20)
No beep sounds.
z
The Key Beep function is OFF.
→ Turn ON the Key Beep function. (p. 65)
The keypad does not work.
z
The keypad is locked.
→ Hold down [CLR
é
] for 1 second to lock or unlock the keypad. (p. 17)
Individual or Group ID cannot be set.
z
The entered ID code is incorrect. The first digit must be set to between ‘1’ and ‘9’ for an
Individual ID.
→ Enter a correct ID code. (p. 22)
“??” blinks instead of the position and time.
z
4 hours have passed since you manually entered the position.
z
The GPS position is invalid.
→ Enter the position and time. (p. 23)
“No Position No Time” are displayed instead of the position and time.
z
The built-in GPS antenna is obstructed, which interrupts the GPS signals from the
satellites.
→ Use the transceiver in a place where nothing interrupts the satellite signal.
z
The position and time have not been manually entered.
→ Enter the position and time. (p. 23)