![background image](http://html1.mh-extra.com/html/icom/ic-m93d-euro/ic-m93d-euro_instruction-manual_2038056005.webp)
iv
PRECAUTIONS
DO NOT
push [PTT] unless you actually intend to transmit.
BE CAREFUL!
The IC-M93D and IC-M93D EURO meet
IPX7* requirements for waterproof protection. However,
once the transceiver has been dropped, waterproof
protection cannot be guaranteed because of possible
damage to the transceiver’s case or the waterproof seal.
* Only when the speaker microphone jack cover, the
optional HM-165, or HM-228 is attached.
Even when the transceiver power is OFF, a slight current
still flows in the circuits. Remove the battery pack from the
trans ceiver when not using it for a long time. Otherwise, the
installed battery pack or batteries will become exhausted,
and will need to be recharged or replaced.
BE CAREFUL!
Even if the volume level is set low, the
beeps of the Float ’n Flash, DSC alarm and AquaQuake
functions are very loud.
BE SURE
the transceiver power is OFF before connect ing
the supplied or optional equipment.
Icom, Icom Inc. and the Icom logo are registered trademarks of Icom
Incorporated (Japan) in Japan, the United States, the United Kingdom, Germany,
France, Spain, Russia, Australia, New Zealand, and/or other countries.
RECOMMENDATION
CLEAN THE TRANSCEIVER THOROUGHLY WITH
FRESH WATER
after exposure to saltwater, and dry
it before operating. Otherwise, the transceiver's keys,
switches and controllers may become unusable, due to salt
crystallization, and/or the charging terminals of the battery
pack may rust.
NOTE: DO NOT
wash the transceiver in water if there
is any reason to suspect the waterproofing may not be
effective. For example, in cases where the [SP MIC] jack
cover is damaged, the transceiver/battery pack is cracked
or broken, or has been dropped, or when the battery pack
is detached from the transceiver.