64
13
TROUBLESHOOTING
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
PROBLEM
POSSIBLE CAUSE
SOLUTION
REF.
You cannot turn ON the
transceiver.
•
The Battery is exhausted or over
discharged.
•The Battery pack is not correctly attached.
• Recharge the battery pack.
•
Correctly attach the battery pack.
p. 61
p. 2
Little or no sound
comes from the
speaker.
•The squelch level is set too high.
•The volume level is set too low.
•
The speaker has been exposed to water.
• Water has entered to the speaker
microphone connector.
•Set the squelch to the threshold point.
•Set the volume to a suitable level.
•
Remove the water using the AquaQuake
function.
•Dry the speaker microphone connector.
p. 13
p. 15
–
You cannot transmit
• Some channels are preset for low power
or receive only by regulations.
•
The battery is exhausted.
•The battery is overcharged.
•The output power is set to low.
•
Change channels.
• Recharge the battery pack.
•
Confirm that the battery voltage is correct.
• Push the software key below
to select
high power.
p. 14
p. 61
p. 5
Scan does not start
•
Favorite channels are not set.
•
Set the Favorite channels.
p. 17
No beeps sound
•
Key Beep is set to OFF.
•
Turn ON the Key Beep on the
“Configuration” screen.
p. 57
You cannot send DSC
calls
•
MMSI (DSC self ID) code is not entered.
•
DSC Switch is set to OFF.
•
Enter the MMSI (DSC self ID) code.
•
Turn ON the DSC Switch in the Menu.
p. 9
p. 42
You cannot receive
GPS position data
•
The built-in GPS antenna is obstructed,
which interrupts the GPS signals from the
satellites.
•
Use the transceiver in a place where
nothing interrupts the satellite signal.
–