Icom IC-M402, Инструкция по эксплуатации

Страница: 40 / 50

34
10
HM-127 REMOTE-CONTROL MICROPHONE
■
Set mode programming
Set mode is used to change the condition of the transceiver’s
functions and the microphone’s own functions:
In this section, instructions are for the microphone’s own func-
tions only. Refer p. 30–33 for the setting of the other func-
tions. (Some functions may not be selected from the micro-
phone.)
ï ï Entering set mode
q
Turn power OFF.
w
While pushing [16•9], turn power ON.
• After beep emission, a set mode item (in the channel name indi-
cator and condition in the channel number readout) is displayed.
e
Push [16•9] to select the desired item, if necessary.
r
Push [
Y
]/[
Z
] to select the desired condition of the item.
t
Turn power OFF, then ON to exit set mode.
• Beep tone “BEEP”
➥
Push [
Y
] to turn ON,
[
Z
] to turn OFF the
beep output.
• LCD contrast “LCD CONTRAST”
➥
Push [
Y
]/[
Z
] to adjust to
a suitable LCD contrast.
■
Intercom operation
q
Push [LO/DX•IC] for 1 sec. to ac-
tivate the intercom function.
• “IC” appears in the priority channel
readout.
• The channel name disappears.
w
Push [PTT] to talk.
• “ ” appears in the channel
name indicator.
e
Release [PTT] to listen.
• “ ” appears in the channel name indicator when the trans-
ceiver is in talking mode.
r
Push [LO/DX•IC] to cancel the intercom function.
• Pushing [16], [SCN•TAG] or [CH/WX] is also cancels the inter-
com function.
For your reference:
In case the intercom mode is selected with the transceiver
during microphone power OFF, the microphone power is au-
tomatically turned ON and the intercom mode is selected.
ï ï Intercom beep function
➥
Push [LO/DX•IC] for more than 1 sec.
• Emits intercom beep while holding.
Push
Push
• •
• •
Appears when the inter-
com function is in use.
00_IC-M402_S.qxd 02.2.21 0:08 PM Page 34 (1,1)