Icom IC-M402, Инструкция по эксплуатации

Страница: 17 / 50

11
6
DSC OPERATION
■
MMSI code programming
The 9-digit MMSI (DSC self ID) code can be programmed at
power ON.
This function is not available when the MMSI code has
been programmed by the dealer. This code programming
can be performed only 2 times.
q
Turn power OFF.
w
While pushing [DSC], turn power ON to enter MMSI code
programming condition.
e
After the display appears, release [DSC].
r
Select the desired number by pushing [
Y
]/[
Z
] .
t
Push [H/L] to advance the cursor.
• Push [CH/WX] to move the cursor backward.
y
Repeat steps
r
and
t
to input 9 digit code.
u
Push [DSC] to input and set the code.
• The previously selected channel ap-
pears.
■
MMSI code check
The 9-digit MMSI (DSC self ID) code can be checked.
q
Push [DSC] to select the DSC menu.
w
Push [
Y
]/[
Z
] to select “MMSI” and
push [DSC].
e
Check the 9-digit MMSI (DSC self ID)
code.
r
Push [DSC] to exit the condition.
■
Position indication
When a GPS receiver (NMEA0183 ver. 2.0) is connected, the
transceiver can display the current position and time.
➥
While pushing [H/L], push [DSC] for 1 sec. to display the
current
position.
• “Latitude and longitude are displayed alternately.
00_IC-M402_S.qxd 02.2.21 0:07 PM Page 11 (1,1)