Icom IC-M402, Инструкция по эксплуатации

Страница: 15 / 50

9
5
SCAN OPERATIONS
■
Setting tag channels
For more efficient scanning, add desired channels as tag
channels or clear tag channels for unwanted channels. Chan-
nels set as non-tag channels will be skipped during scanning.
Tag channels can be assigned to each channel group
(U.S.A., International, Canada) independently.
q
While pushing [H/L], push [CH/WX] one or more times to
select the desired channel group, if desired.
w
Select the desired channel to set as a tag channel.
e
Push [
Y
] and [
Z
] simultaneously for 1 sec. to set the dis-
played channel as a tag channel.
• “TAG” appears in the function display.
r
To cancel the tag channel setting, repeat
e
.
• “TAG” disappears.
• Clearing all tag channels in the selected channel group
➥
While pushing [
Y
] and [
Z
], Turn power ON to clear all tag
channels in the channel group.
■
Starting a scan
Set scan type (priority or normal scan) and scan resume timer
in advance using set mode. (p. 20)
q
Set tag channels as described at left.
w
Make sure the squelch is closed to start a scan.
e
While pushing [H/L], push [CH/WX] one or more times to
select the desired channel group, if desired.
r
Push [
Y
] or [
Z
] for 1 sec. to start priority or normal scan.
• “Pri scan 16” or “Normal scan” appears in the function display.
• When a signal is detected, scan pauses until the signal disap-
pears or resumes after pausing 5 sec. according to set mode set-
ting. (Channel 16 is still monitored during priority scan.)
•While in the scanning, use [
Y
] and [
Z
] key to check tag channels,
change the scanning direction or resume the scan manually.
• “16” flashes and a beep tone sounds when a signal is received
on Channel 16 during priority scan.
• Push
[
Y
]
and
[
Z
]
for 1 sec. to set the paused channel as a tag
channel.
t
To stop the scan, push [
Y
] or [
Z
].
Scan starts. When a signal is received
[Example]: Starting a priority scan.
00_IC-M402_S.qxd 02.2.21 0:07 PM Page 9 (1,1)