7
APCO P25 MODE OPERATION
7-4
Transmitting a call (Continued)
D
Transmitting a Status Message
You can transmit a preset simple message.
A voice signal cannot be sent at the same time.
(Menu > Signaling/Call >
Call Menu
)
1. Push [Menu] to display the Menu screen.
2. Push [Left] or [Right] to select “Signaling/Call,”
then push [OK].
3. Push [Up] or [Down] to select “Call Menu,” then
push [OK].
4. Select “Status,” then push [OK].
5. Select a Status Message, then push [OK].
6. Select the target Individual station, then push
[PTT] to transmit the message.
• “Success” is displayed after receiving an
acknowledgment from the target station.
• “Failed” is displayed if the target station does not send
back an acknowledgment.
TIP:
• You can also transmit a Status message through
“Status.”
(Menu > Signaling/Call >
Status
)
• Push [Call Menu] to directly display the “Call
Menu” screen in step 4 to the left.
• Push [Status] to directly display the “Status”
screen in step 5 to the left.
• Hold down [Status] for 1 second transmit the
preset Status Message to the currently selected
destination.
NOTE:
If the following settings are confi gured using
the CS-F7500
programming
software
, the Status
message can be automatically transmitted when the
transceiver is turned ON or OFF.
Set the Status message to be transmitted in
“Power ON Status” or “Power OFF Status” item,
respectively.
Set the target station ID in “Power Status ID.”
(Digital > Status > Status Setting)
