2
PANEL DESCRIPTION
2-18
Category: Channel/Scan (Voting) (Continued)
Scan Add/Del (Tag)
z
Push to add a channel to, or delete it from the
current Scan list
•
When a channel is added to the current Scan list, the
current Scan list text and “ON” are briefly displayed.
•
When a channel is deleted from the current Scan
list, the current Scan list text and “OFF” are briefly
displayed
z
You can add a channel to, or delete it from a
selected Scan list
1 Hold down for 1 second to display the “Scan Tag”
screen
2 Push [Up] or [Down] to select a list
3 Push [OK] to add a channel to, or delete it from
the selected list
•
When a channel is added to the selected Scan
list, the current Scan list text and “ON” are briefly
displayed
•
When a channel is deleted from the selected Scan
list, the current Scan list text and “OFF” are briefly
displayed
4 Push [Back] to exit the “Scan Tag” screen
z
While a Scan is paused by detecting a signal on a
channel (except for primary or secondary channel),
push this key to remove the channel from the Scan list
TIP:
When the Nuisance Delete function is ON,
the removed channel is automatically added to the
Scan list again, after the Scan is canceled
High/Low
Push to select the transmit output power level
temporarily or permanently, depending on the
presetting
NOTE:
When
Forced RF Power Low 1 when Low
Battery
is set to “ON,” the output power is forcibly
set to Low 1 when the battery is low, regardless of
this key operation
L
CS-F3400DP
programming
software
(
Common -
Battery Setting - Low Voltage Operation -
Forced RF Power
Low 1 when Low Battery
)
C.Tone CH Select
In the Analog mode
Push to display the “CTone CH Select” screen Then
push [Up] or [Down] to select a tone frequency or
code After selecting, push [OK] to save
Tone/CC CH Select
In the Analog mode
Push to display the “CTone CH Select” screen Then
push [Up] or [Down] to select a tone frequency or
code After selecting, push [OK] to save
In the Digital mode (Conventional only)
Push to display the “CC CH Select” screen Then
push [Up] or [Down] to select a CC After selecting,
push [OK] to save
Monitor
z
Push to turn the CTCSS (DTCS), 2-Tone, or 5-Tone
squelch mute ON or OFF
L
Only during 2-Tone mode operation, push to open any
squelch, or deactivate any mute functions
L
Only during 5-Tone mode operation, push to activate
one or two of the following functions on each channel
(Depending on the presetting):
- Hold down to unmute the channel (Audible mode)
- Push to mute the channel (Inaudible mode)
NOTE:
The audible (unmute) mode may
automatically return to the Inaudible (mute) mode,
after the preset time period
z
Depending on the presetting, holding down this key
for 1 second may cancel the Scan
Talk Around
Push to turn the Talk Around function ON or OFF
L
The Talk Around function equalizes the transmit
frequency to the receive frequency, for direct (Simplex)
communication
Bandwidth
In the Analog mode
Push to temporarily set the channel width to Wide* or
Narrow
L
The wide passband width can be preset to either 250
kHz (Wide) or 200 kHz (Mid)
Depending on the presetting, Mid channel width may be
selectable
* The Wide channel width is not usable for the USA version
transceivers
D
For keys and keypads
Assignable Software key functions
