![background image](http://html.mh-extra.com/html/icom/ic-9100/ic-9100_instruction-manual_612373165.webp)
156
12
SATELLITE OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
N
0REPARATION
q
Decide on a usable satellite, and point your antenna
direction towards it.
w
Confirm the approximate location of the satellite
and operating mode (e.g. “B,” “J,” etc.) through a
publication (magazine, etc.) or an appropriate sat-
ellite tracking software.
e
Push [SATELLITE] to enter the satellite mode.
r
Push [NOR/REV](7 3) to toggle between normal
and reverse tracking.
t
Select the operating mode as listed below.
s4OSELECTTHEOPERATINGMODEFORTHEUPLINKPUSH;35"=
before selecting the operating mode.
Satellite
Downlink
(MAIN band)
Uplink
(SUB band)
Reverse tracking type
USB (or CW)
LSB (or CW)
Normal tracking type
USB (or CW)
LSB (or CW)
y
Select the desired downlink frequency in the MAIN
band to match the beacon frequency.
s2EFERTOAHAMMAGAZINEORBOOKFORDETAILEDINFORMA
-
tion.
s!DJUSTTHEANTENNADIRECTIONSOTHATTHE3METERSHOWS
its strongest level.
s4HE3METERLEVELSHOULDBENOTEDTOADJUSTTRANSMIT
power during a loop test.
u
Perform a loop test.
,OOPTESTPROCEDURES
q
Rotate [MAIN DIAL] to select a vacant frequency,
within the satellite’s coverage, as the downlink
frequency on the MAIN band.
w
Push [PTT] on the microphone to transmit. (or
[TRANSMIT] on the transceiver)
e
Push [SUB](3.5 2), then select the uplink fre-
quency on the SUB band while transmitting a
single tone such as a whistle to find your down-
link signal and monitor your own signal correctly.
r
Push [SUB](3.5 2) again after setting.
./4%
To avoid excessive power, set the output
power so that the downlink signal strength is lower
than the beacon’s strength.
i
Select the desired frequency to begin your satellite
communications.
s"OTHTHEDOWNLINKANDUPLINKFREQUENCIESCHANGESIMUL
-
taneously.
o
When your downlink audio drifts (Doppler effect),
push [SUB](3.5 2) then rotate [MAIN DIAL] to adjust
the uplink frequency (SUB band).
After adjusting, push [SUB](3.5 2) again.
s7HENAPARTICULARSTATIONSAUDIOISOFFFREQUENCYUSE
the RIT function (push [RIT]).
!0
To exit the satellite operation, push [SATELLITE].
For your convenience
As the transceiver has 20 satellite memory channels,
once entered, desired satellite frequencies can be
recalled instantly.
A G C
D U P
C O M P T B W
S C P
M1
Satellite and
tracking icon
Uplink (transmit) frequency
Downlink (receive) frequency
A G C
D U P
C O M P T B W
S C P
M1
A G C
D U P
C O M P T B W
S C P
M1
Select the downlink frequency to match with
the beacon frequency.
Select a vacant frequency as the downlink fre-
quency, within the satellite’s coverage.
A G C
D U P
C O M P T B W
S C P
M1
Adjust the uplink frequency