Icom IC-80AD, Инструкция по эксплуатации

Страница: 117 / 188

109
10
SCAN OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
t
Push and hold [S.MW] (M/CALL) for 1 sec. to store the skip
condition into the memory.
• “SKIP” or “PSKIP” indicator appears, according to the skip selec-
tion in the step
r
.
Skip channel setting Program skip setting
“SKIP” appears “PSKIP” appears
CONVENIENT!
The skip setting can be set with the following operation.
[DIAL]
q
Select the desired memory channel to be set as a skip
channel/frequency.
w
While pushing [SKIP] (5), rotate
[DIAL] to select the skip condition
from “PSKIP,” “SKIP” and “OFF
(no in-
dication)
.”
CONVENIENT!
During VFO scanning, such as programmed scan, the skip
setting can be programmed into the highest blank memory
channel which is automatically selected with the following op-
eration.
q
Start the VFO scan.
± Push
[V/MHz]
to select VFO mode.
• Select the desired frequency band with [BAND] , if desired.
±
Set the squelch level.
± While pushing and holding [SCAN] (V/MHz) for 1 sec. to
enter scan type selection, then rotate [DIAL] to select
the desired scan type.
• “ALL” for full scan; “BAND” for band scan, “P-LINK x” for pro-
grammed link scan (x= 0 to 9), “PROG
xx
(or scan name
if programmed)” for programmed scan (
xx
= 0 to 24; pro-
grammed scan edges numbers are only displayed), “DUP”
for duplex scan.
±
Push [SCAN] (V/MHz) again to start the scan.
• Scan pauses when a signal is received.
• Rotate
[DIAL] to change the scanning direction, or resumes
manually.
w
When scan pauses and you want to set the paused fre-
quency as a skip frequency.
± Push and hold [SKIP] (5) for 1 sec. to store the paused
frequency into the highest blank memory channel.
• While pushing and holding [SKIP] (5), scan pauses; and when
releasing [SKIP] (5) scan resumes.