9
Figure 3: Network Terminal Block (CN3) and Duplex Selection Jumpers
7. Connect the RS-485 network cable to the 4-position pluggable terminal
block on the drive’s control board labeled CN3 (refer to Figure 1 and
Figure 3.) Refer to section 3 of this manual for detailed network
connection information. Ensure that the terminal block is fully seated into
the terminal block header, and route the network cable such that it is
located well away from any drive input power or motor wiring. Also take
care to route the cable away from any sharp edges or positions where it
may be pinched.
8. Take a moment to verify that the ASD-NANOCOM interface is fully seated
in the drive control board’s J4/J5 connectors, that the duplex selection
jumpers are both in the “HALF” position, that the network cables are
properly terminated in CN3, that CN3 is fully seated in its header, and that
the RS-485 network cable has sufficient clearance from the drive’s input
power and output motor wiring. Refer to Figure 4.
9. Reinstall the drive’s front cover / close the drive’s cabinet door.
10. Turn the power source to the drive ON, and verify that the drive functions
properly. If the drive does not appear to power up, or does not function
properly, immediately turn power OFF.
Repeat steps 1 and 2 to remove
all power from the drive.
Then, verify all connections. Contact ICC or
your local Toshiba representative for assistance if the problem persists.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]
