s. 8 / 40
AUTOMATIC POWER FACTOR
CONTROLLER
RPC 8BGA
WARNING!
Carefully read the manual before the installation or use.
This equipment is to be installed by qualified personnel, complying to current standards, to avoid damages or safety hazards.
Before any maintenance operation on the device, remove all the voltages from measuring and supply inputs and short-circuit the CT input terminals.
Products illustrated herein are subject to alteration and changes without prior notice.
Technical data and descriptions in the documentation are accurate, to the best of our knowledge, but no liabilities for errors, omissions or contingencies arising there
from are accepted.
A circuit breaker must be included in the electrical installation of the building. It must be installed close by the equipment and within easy reach of the operator.
It must be marked as the disconnecting device of the equipment: IEC /EN 61010-1 § 6.11.2.1.
Index
1. Introduction
2. Description
3. Front keyboard
4. Front LEDs
4.1. Alarm LED (red)
5. Operating modes
5.1. Manual mode (MAN)
5.2. Automatic mode (AUT)
5.3. TEST Mode
6. Main menu
7. Password access
8. Display page navigation
9. Target power factor set-up
10. Harmonic analysis page
15. Remote-controlled variables (REMx)
16. User Alarms (UAx)
17. Master-Slave configuration
18. IR programming port
19. Parameter setting (setup) with PC
20. Parameter setting (setup) from front panel
21. Parameter table
22. Alarms
22.1. Alarm description
22.2. Alarm properties
22.3. Alarm properties table
24. Input function table
25. Output function table
GB
Operating manual
(user version )
