15
Instruction Manual C100
The nominal value indicates the value to be chosen as zero point of the column display. If the nominal
value is 20 mm (
SEt.Pnt
. is set to 20 mm ) the column display will show a deviation of 0,1 mm for a work
piece measuring of 20,1 mm.
Notice :
The nominal value is used only for the zero position of the column display and does not
influence the numeric display.
In this menu you can set a maximum of 4 tolerance points representing relative deviation from the
nominal value.
Programming starts by selecting one of the four tolerance marks on the column display :
+
red
upper tolerance ( red )
+ yellow
upper tolerance ( yellow )
– yellow
lower tolerance ( yellow )
– red
lower tolerance ( red )
The chosen tolerance point flashes. Go to the next point using the
Ï
and
Ð
keys and confirm with
ENTER
key. After this you can switch the tolerance point on or off by selecting
on / oFF
on the numeric
display
.
You can set the relative deviation from the nominal value ( max. ± 1.5 mm ), if the tolerance point
is switched on.