13
Instruction Manual C100
3.4 Programming menu
Press the
PRG/CAL
key to switch from Measurement to Programming mode.
-
'SEt OP.'
flashes on the numeric display.
The programming of the column gauge starts with the selection of the Measuring mode :
Manual gauge switching
Automatic gauge switching
Press the
ENTER
key to confirm '
SEt OP.
' The lamp
AUTO Mode
lights up and
on
or
oFF
flashes on the
numeric display.
Use the
Ï
and
Ð
keys to enable ( on ) or disable ( oFF ) automatic gauge switching. Confirm your choice
by pressing the
ENTER
key.
Press the
Ð
key to advance to the next menu.
In this menu you can switch on or off the gauges 1...4 and access both Programming mode for
the gauges 1...4 and the SetUP menu.
Press the
Ï
and
Ð
keys to select the gauges 1...4 and the SetUP menu. In the light fields of
Programming mode the number of the selected gauge flashes while the numeric display indicates
whether the gauge is switched on or off. The relevant gauge or the SetUP menu can be chosen by
pressing the ENTER key.
After this you can switch on or off the gauge.
As soon as a gauge is chosen ( on ), programming of the gauge for the unit starts immediately.
Notice :
If all gauges are switched off the error message
'Err 7'
appears on the numeric
display because measurement operation is not possible.