IBM xSeries 235, Техническое обслуживание и устранение неисправностей

Страница: 131 / 214

5. Disconnect the hot-swap card cable from the system board.
6. Press the two tabs on the hot-swap card and remove it from the chassis.
Note: It might be easier to remove this component if the server is placed on its
side.
7. To replace the hot-swap card, line up the two tabs with the notches on the
chassis and snap the assembly into place; then, connect the cable to the
system board.
Diagnostics panel card
Complete the following steps to remove the diagnostics panel card.
Note:
v Read “Installation guidelines” on page 41.
v
Read the safety notices at “Safety information” on page 163.
v Read “Handling electrostatic discharge-sensitive devices” on page 166.
1. Turn off the server.
2. Disconnect all external cables and power cords from the back of the server.
3. Remove the server cover (see “Removing the left-side cover” on page 51).
4. Disconnect and remove adapters and spacers (see “Working with adapters” on
page 56).
5. Remove the two central fans (see “Replacing a hot-swap fan” on page 91).
6. Remove the plastic baffle.
Chapter 5. Service replaceable units
121