IBM xSeries 235, Техническое обслуживание и устранение неисправностей

Страница: 101 / 214

g. If your server has the 3-Pack Ultra320 Hot-Swap Expansion option
installed, connect the power connector (P8) to the power connector on the
3-Pack backplane.
8. Reinstall the adapter-support bracket. See “Removing and installing the
adapter-support bracket” on page 54 for instructions.
9. Replace the server cover (see “Installing the server bezel and left-side cover
(tower model)” on page 96 or “Installing the server bezel and top cover (rack
configuration)” on page 99.
10. Plug one end of each power cord into the corresponding connector on the
power supply; then, plug the other end of each power cord into a properly
grounded electrical outlet.
Note: You can route the power cords through the power-cord restraint bracket
on the rear of the server (tower model only).
11. If the server is not on, turn on the server.
12. Verify that the dc power LED and the ac power LED on each power supply are
lit, indicating that the power supply is operating properly.
Replacing a hot-swap fan
Your server comes with six hot-swap fans (two front fans in connector J50, two
center fans in connector J18, and two rear fans in connector J25). The two largest
fans (in connector J50) are also known as blowers. You do not need to turn off the
power to the server to replace a hot-swap fan.
Attention: To help ensure proper cooling, if a fan fails, replace it within 48 hours.
The following illustration shows how to replace hot-swap fans.
Fan-release
latch
Fan-assembly
latch
Hot-swap fan
assembly
Release lever
Hot-swap fan
Rear fan 1 or 2
Front fan 5 or 6
Center fan
3 or 4
Chapter 4. Customer replaceable units
91