IBM Ultrium Internal Tape Drive T200, Справочное руководство

Страница: 37 / 126

TapeAlert Log
The TapeAlert log page is page 2Eh. There are 64 parameters, numbered from 1
through 64. Only parameters 1 through 18, 20 through 23, and 29 through 39 have
definitions for tape drives without attached loaders. The remaining parameters are
always 0.
All parameters are 1 byte long. Each parameter is either 0 to indicate the
corresponding condition has not occurred or 1 to indicate that the corresponding
condition has occurred. All log parameters are cleared when the log is read. The
Log is also cleared at power-on, on a reset condition, or by a LOG SELECT
command. Specific flags may be cleared when corrective action has removed the
condition that caused the flag to be set.
The supported parameters are listed in Table 22. For a description of service
actions associated with these parameters, refer to the IBM Ultrium Internal Tape
Drive Models T200 and T200F Setup, Operator, and Service Guide or the IBM 3580
Ultrium Tape Drive Setup, Operator, and Service Guide.
Table 22. TapeAlert Log Parameters
Parameter Description Type DU LP LBIN
3 Hard Error Warning 1 0 0
4 Media Critical 1 0 0
5 Read Failure Critical 1 0 0
6 Write Failure Critical 1 0 0
7 Media Life Warning 1 0 0
8 Not Data Grade Warning 1 0 0
9 Write Protect Critical 1 0 0
10 No Removal Information 1 0 0
11 Cleaning Media Information 1 0 0
12 Unsupported Format Information 1 0 0
15 Memory in Cartridge Failure Warning 1 0 0
16 Forced Eject Critical 1 0 0
18 Tape Directory Corrupted Warning 1 0 0
19 Nearing Media Life Information 1 0 0
20 Clean Now Critical 1 0 0
21 Clean Periodic Warning 1 0 0
22 Expired Cleaning Media Critical 1 0 0
23 Invalid Cleaning Cartridge Critical 1 0 0
30 Hardware A Critical 1 0 0
31 Hardware B Critical 1 0 0
32 Interface Warning 1 0 0
33 Eject Media Critical 1 0 0
34 Download Fault Warning 1 0 0
35 Drive Humidity Warning 1 0 0
36 Drive Temperature Warning 1 0 0
37 Drive Voltage Warning 1 0 0
Chapter 2. Command Support
23
|
|
|
|