IBM TotalStorage, Руководство по установке

Страница: 21 / 91

CAUTION:
A lithium battery can cause fire, explosion, or a severe burn. Do not recharge,
disassemble, heat above 100°C (212°F), solder directly to the cell, incinerate, or
expose cell contents to water. Keep away from children. Replace only with the
part number specified for your system. Use of another battery might present a
risk of fire or explosion. The battery connector is polarized; do not attempt to
reverse the polarity. Dispose of the battery according to local regulations. (51)
Related topics:
v
“Definitions of notices” on page viii
v
IBM TotalStorage SAN Volume Controller: Translated Safety Notices
Handling static-sensitive devices
Attention: Static electricity can damage electronic devices and your system. To
avoid damage, keep static-sensitive devices in their static protective bags until you
are ready to install them.
To reduce the possibility of electrostatic discharge, observe the following
precautions:
v Limit your movement. Movement can cause static electricity to build up around
you.
v
Handle the device carefully, holding it by its edges or its frame.
v
Do not touch solder joints, pins, or exposed printed circuitry.
v
Do not leave the device where others can handle and possibly damage the
device.
v
While the device is still in its anti-static bag, touch it to an unpainted metal part
of the system unit for at least 2 seconds. (This action removes static electricity
from the package and from your body.)
v
Remove the device from its package and install it directly into your SAN
Volume Controller, without putting it down. If it is necessary to put the device
down, place it onto its static-protective bag. (If your device is an adapter, place it
component side up.) Do not place the device onto the cover of the SAN Volume
Controller or onto a metal table.
v
Take additional care when handling devices during cold weather because
heating reduces indoor humidity and increases static electricity.
About this guide
xix