IBM TotalStorage, Руководство по установке

Страница: 14 / 91

2. Check the frame for damage (loose, broken, or sharp edges).
3.
Check the power cables and ensure that:
a. The third-wire ground connector is in good condition. Use a meter to check
that the third-wire ground continuity is 0.1 ohm or less between the
external ground pin and the frame ground.
b. The insulation is not worn or damaged.
4. Check for any obvious nonstandard changes. Use good judgment about the
safety of any such changes.
5. Check inside the SAN Volume Controller for any obvious unsafe conditions,
such as metal particles, water or other fluids, or marks of overheating, fire, or
smoke damage.
6.
Check for worn, damaged, or pinched cables.
7. Ensure that the voltage specified on the product-information label matches the
specified voltage of the electrical power outlet. If necessary, verify the voltage.
8.
Inspect the power supply assemblies, and check that the fasteners (screws or
rivets) in the cover of the power-supply unit have not been removed or
disturbed.
9. Before connecting the SAN Volume Controller to the SAN, check the
grounding.
Related topics:
v
“Checking the grounding of the SAN Volume Controller and the uninterruptible
power supply” on page xiii
External machine checks
This topic describes the checks that you should perform on the outside of the SAN
Volume Controller.
Steps:
Perform the following external machine checks before you install the SAN Volume
Controller:
1. Verify that all external covers are present and are not damaged.
2. Ensure that all latches and hinges are in the correct operating condition.
3.
If the SAN Volume Controller is not installed in a rack cabinet, check for loose
or broken feet.
4. Check the power cord for damage.
5.
Check the external signal cable for damage.
6. Check the cover for sharp edges, damage, or alterations that expose the internal
parts of the device.
7. Correct any problems that you find.
Related topics:
v “Inspecting the SAN Volume Controller for unsafe conditions” on page xi
Internal machine checks
This topic describes the checks that you should perform on the inside of the SAN
Volume Controller.
Steps:
xii
Installation Guide