IBM TotalStorage FAStT600, Инструкция по установке и эксплуатации

Страница: 60 / 134

Removing SFP modules
To remove the SFP module from the host port, perform the following steps.
Attention: To avoid damage to the cable or the SFP module, make sure you
unplug the LC-LC Fibre Channel cable before you remove the SFP module.
1. Remove the LC-LC Fibre Channel cable from the SFP module. For more
information, see “Handling fiber-optic cables” on page 27.
2. Unlock the SFP module latch:
v
For SFP modules containing plastic tabs, unlock the SFP module latch by
pulling the plastic tab outward 10°, as shown in Figure 25.
v For SFP modules containing wire tabs, unlock the SFP module latch by
pulling the wire latch outward 90°, as shown in Figure 26.
3. With the SFP latch in the unlocked position, extract the SFP module.
v For SFP modules containing plastic tabs, slide the SFP module out of the
port.
v
For SFP modules containing wire tabs, grasp the wire latch and pull the SFP
module out of the minihub port.
4. Replace the protective cap on the SFP module.
5. Place the SFP module into a static-protective package.
6. Replace the protective cap on the port.
Installing fiber-optic cables
To connect the fiber-optic cables, perform the following steps.
Protective cap
SFP module
10
o
Plastic tab
Figure 25. Unlocking the SFP module latch - plastic variety
Protective cap
SFP module
90
o
Wire tab
Figure 26. Unlocking the SFP module latch - wire variety
30
IBM TotalStorage FAStT600 Fibre Channel Storage Server: Installation and User’s Guide