IBM TotalStorage FAStT600, Инструкция по установке и эксплуатации

Страница: 44 / 134

Installing the storage server in a rack
Review the documentation that comes with the rack cabinet for safety and cabling
information. When you install the storage server in a rack, consider the following
factors:
v
Ensure that the room air temperature is below 35°C (95°F).
v
Do not block any air vents. Usually, leaving 15 cm (6 in.) of air space provides
proper airflow.
v Plan the device installation starting from the bottom of the rack.
v
Do not extend more than one device out of the rack at the same time.
v Remove the rack doors and side panels to provide easier access during
installation.
v
Connect all power cords to properly wired and grounded electrical outlets.
v Take precautions to prevent overloading the power outlets when you install
multiple devices in a rack.
Statement 4:
≥ 18 kg (39.7 lb) ≥ 32 kg (70.5 lb) ≥ 55 kg (121.2 lb)
CAUTION:
Use safe practices when lifting.
You will need a flat-blade and a Phillips screwdriver during the installation. The
following items come with your option. If any items are missing or damaged, contact
your place of purchase.
v Cage nuts (10)
v
Clip nuts (10)
v
M6 screws (10)
v
Side rails (2)
Note: See the storage server documentation for handling guidelines before
removing any ESD-sensitive devices. Perform the following steps to install
the storage server in a rack. The first four steps for the installation procedure
involve removing some components from the storage server in order to
reduce the weight of the storage server for easier installation.
1. To remove a RAID controller, push down on the latch centered on the controller;
then, grasp the pull-rings on the levers and pull them to remove the RAID
controller and set it aside for later installation.
If you have a second RAID controller, repeat this step for the second controller.
14
IBM TotalStorage FAStT600 Fibre Channel Storage Server: Installation and User’s Guide