IBM totalstorage 200, Руководство по обслуживанию

Страница: 42 / 180

Error symptoms
Table 6 contains information on error symptoms and suggested actions.
Table 6. Error symptoms and suggested actions
Error Symptom Suspected Part/Suggested Action
CD is not working properly Suggested action
1. Clean the CD
2. Run CD-ROM Diagnostic
CD-ROM drive tray is not working Suspected part: CD-ROM Drive
Suggested action:
1. Ensure the appliance is switched ON
2. Insert the end of a paper clip into the manual tray-release opening
3. Run CD-ROM Diagnostic
CD-ROM drive is not recognized Suspected part:
1. CD-ROM Drive
2. System Board
Suggested action:
1. Run Configuration/Setup, enable primary IDE channel
2. Check cables and jumpers
3. Check for correct device driver
4. Run CD-ROM diagnostics
Power switch does not work and reset
button does work. Suspected part:
1. Power Switch Assembly
2. System Board
Suggested action: Verify that the power-on control jumper on J23
extension cable is on pins 1 and 2
Diskette drive in-use LED stays on, or the
system bypasses the diskette drive, or the
diskette drive does not work. Suspected part:
1. Cable
2. Diskette Drive
3. System Board
Suggested action:
1. If there is a diskette in the drive, verify that:
a. The diskette drive is enabled in the Configuration/Setup utility
program
b. The diskette is good and not damaged (try another diskette if you
have one)
c. The diskette is inserted correctly in the drive
d. The diskette contains the necessary files to start the appliance
e. The program is OK
f. The cable is installed correctly (proper orientation)
2. Run Diskette Drive Diagnostics
26
Models 200 and 225 Service Guide