IBM System x3100 M3, Инструкция по установке и эксплуатации

Страница: 51 / 94

9. If you are installing a 5.2-inch drive in bay 2, slide the drive into the bay. If you
are installing a 3.5-inch drive in bay 2, you must attach the 5.2-inch.
conversion kit to the 3.5-inch drive.
10. Connect one end of the applicable signal cable into the rear of the drive and
make sure that the other end of this cable is connected into the applicable
SATA connector on the system board (see “System-board internal connectors”
on page 16).
Note: Route the signal cable so that it does not block the airflow to the rear of
the drives or over the microprocessor and dual inline memory modules
(DIMMs).
11. Connect the power cable to the rear of the drive. The connectors are keyed
and can be inserted only one way.
If you have other devices to install or remove, do so now; otherwise, go to
“Completing the installation” on page 47.
Installing an optional tape drive
Note: Make sure that you have all the cables and other equipment that is specified
in the documentation that comes with the new drive.
To install an optional tape drive, complete the following steps.
1. Read the safety information that begins on page v and “Installation guidelines”
on page 22.
2. Turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
3. Unlock and remove the side cover (see “Removing the side cover” on page
25).
4. Remove the two-piece bezel (see “Removing the two-piece bezel” on page
26).
5. Use a screwdriver to pry the filler panel and EMC shield away from the server.
Chapter 2. Installing optional devices
35