IBM System x3100 M3, Инструкция по установке и эксплуатации

Страница: 74 / 94

2. The server does not support the DataCenter edition of Microsoft Windows
Server 2008 R2.
1. Go to http://www.ibm.com/systems/support/.
2. Under Product support , click System x .
3. From the menu on the left side of the page, click System x support search .
4. From the Task menu, select Install .
5. From the Product family menu, select System x3100 M3 .
6. From the Operating system menu, select your operating system, and then click
Search to display the available installation documents.
Configuring the Gigabit Ethernet controller
The Ethernet controllers are integrated on the system board. They provide an
interface for connecting to a 10 Mbps, 100 Mbps, or 1 Gbps network and provides
full-duplex (FDX) capability, which enables simultaneous transmission and reception
of data on the network. If the Ethernet ports in the server support auto-negotiation,
the controllers detect the data-transfer rate (10BASE-T, 100BASE-TX, or
1000BASE-T) and duplex mode (full-duplex or half-duplex) of the network and
automatically operates at that rate and mode.
You do not have to set any jumpers or configure the controller. However, you must
install a device driver to enable the operating system to address the controller. For
device drivers and information about configuring the Ethernet controller, complete
the following steps:
1. Go to http://www.ibm.com/systems/support/.
2. Under Product support , click System x .
3. Under Popular links , click Software and device drivers .
4. From the Product family menu, click System x3100 M3 .
Note: Changes are made periodically to the IBM Web site. The actual procedure
might vary slightly from what is described in this document.
Using LSI Configuration Utility program
Use the LSI Configuration Utility program to configure and manage redundant array
of independent disks (RAID) arrays. Be sure to use this program as described in
this document.
v
Use the LSI Configuration Utility program to perform the following tasks:
– Perform a low-level format on a hard disk drive
– Create an array of hard disk drives with or without a hot-spare drive
– Set protocol parameters on hard disk drives
The integrated SAS/SATA controller with RAID capabilities supports RAID arrays.
You can use the LSI Configuration Utility program to configure RAID 1 (IM), RAID
1E (IME), and RAID 0 (IS) for a single pair of attached devices. In some server
models, the ServeRAID-BR10il SAS/SATA controller v2 provides RAID levels 0 and
1 support.
In addition, you can download an LSI command-line configuration program from
http://www.ibm.com/systems/support/.
58
System x3100 M3 Type 4253: Installation and User’s Guide