IBM Storwize V7000, Руководство пользователя

Страница: 105 / 152

6. Pull the slide rail forward and locate the front latch in the appropriate unit
space in front of the rack EIA rail. Adjust the length of the rail.
7. Press the blue button to release the bracket. Push the front latch in all the way.
Make sure the latch is fully engaged. Refer to Figure 41.
8. Repeat this procedure to install the other rail into the rack Make sure that each
front latch is fully engaged.
Installing the file modules in the rack
About this task
To install each file module in the rack, follow these instructions:
1. Pull the slide rails forward
1
until they click, two times, into place. Carefully
lift the file module and tilt it into position over the slide rails so that the rear
nail heads
2
on the device line up with the slide rails. Slide the file module
down until the rear nail heads slip into the two rear slots, and then slowly
lower the front of the file module
3
until the other nail heads slip into the
ifs00023
Figure 40. Install the rear end of the slide rails
ifs00024
Figure 41. Install the front end of the slide rails
Chapter 5. Performing the hardware installation
85