IBM Storwize V7000, Руководство пользователя

Страница: 127 / 152

Chapter 6. Start adding the file modules
This document helps you set up your file modules for the first time.
About this task
Before you begin, make sure that you have completed the tasks in Chapter 3,
“Before you begin adding file modules,” on page 41 and Chapter 4, “Preparing for
installation,” on page 69. This section guides you through setting up your file
modules for the first time.
You should have already installed the latest version of the update to NAS checker
utility (up2nas) on the Storwize V7000 and run it as part of working through the
Chapter 3, “Before you begin adding file modules,” on page 41 section of this
guide. Run up2nas again to start the initial setup of the file modules. You must
provide the management IP addresses that the file modules will use and the USB
flash drive that came in the documentation pack with the file module shipment.
Begin by running up2nas again on the Storwize V7000 system CLI:
v up2nas checks that the Storwize V7000 is in a good state for file modules to be
added.
v
up2nas asks you for the new management IP addresses which it checks.
v
up2nas asks you to put the USB flash drive into the Storwize V7000 control
enclosure on which up2nas is running so that it can put the files onto it which
starts the initial setup of the file modules.
v
You are instructed to insert the USB flash drive into the upper file module so
that it becomes node 1. The configuration files put onto it by the control
enclosure are used to setup the management communication paths in the
Storwize V7000 Unified system.
v
You are instructed to wait for the blue identify indicator on each file module to
go out or to start blinking again. This should only take a few minutes but it can
take more than one hour if the Storwize V7000 Unified software level is older
than 1.3.2.
v
You will be instructed to put the USB flash drive into a Windows PC and run
the initialization tool executable program on it.
v
If this part of the initial setup of the file modules has completed successfully
then the initialization tool provides a link to the management GUI where the
progress to completion of the initial setup can be seen.
v
If there was a problem with this part of the initial setup of the file modules then
the initialization tool provides the error code and links you to the Information
Centre page that helps you to troubleshoot the problem.
v If you cannot run InitTool.exe then look for Output Result in the
SONAS_result.txt file on the USB flash drive.
v
If the initial setup does not complete successfully then the management GUI
provides the error code and links you to the Information Center page that helps
you to troubleshoot the problem.
© Copyright IBM Corp. 2012, 2014
107