IBM SAN Volume Controller 2145-CF8, Руководство по установке оборудования

Страница: 54 / 101

5. To install the cable-management arm assembly, you must place the
cable-management arm mounting bracket into the same slide rail onto which
you installed the cable-management support arm.
The cable-management support arm is not shown in Figure 27.
Push the blue latch on the cable-support-arm stop bracket
1
to slide the
mounting bracket
2
into the left slide rail. Push the bracket into the slide rail
until the bracket snaps into place.
6. Place the cable-management arm on the support arm.
a.
Pull out the cable-management arm pin, as shown by
1
in Figure 28 on
page 29, then slide the cable-management arm tab
2
into the slot on the
inside of the slide rail.
b. Push the tab until it snaps into place.
c. Pull out the other cable-management arm pin
3
, then slide the
cable-management arm tab into the slot
4
on the outside of the slide rail.
d. Push the tab until it snaps into place.
svc_bb1ka035
1
2
Figure 26. Attaching the free end of the SAN Volume Controller 2145-CF8 support arm
svc_bb1ka040
1
2
Figure 27. Rack rear: Installing the SAN Volume Controller 2145-CF8 cable-management arm
mounting bracket
28
IBM System Storage SAN Volume Controller: Model 2145-CF8 Hardware Installation Guide