IBM SAN Volume Controller 2145-CF8, Руководство по установке оборудования

Страница: 51 / 101

1. Verify that you have all the items that you need for installing the support rails
and that you have identified the front of each rail, as shown in Figure 20 on
page 24.
1
Slide rail (left)
2
Slide rail (right)
5
M6 screws
8
Front of rails
Note: You might find it helpful, with some types of racks, to remove the rack
doors and side panels to provide easier access during installation.
2. Prepare each slide rail for installation.
a.
Select one of the slide rails that is marked with either an R (right) or an L
(left), as shown in Figure 21.
b. Push up on the front moveable tab
1
.
c.
To slide out the front side rail, pull out the front latch
2
.
d. Slide out the front rail.
e. If a thumbscrew is installed in the slide rail
3
, remove it.
3. Install the rear of the rail into the rear of the rack.
a. From the front of the rack, line up the three pins on the rear of the slide rail
with the three holes in the selected U on the rear of the rack.
b. Push the rails so that the pins go into the holes, as shown by
1
in
Figure 22 on page 26.
c.
Drop the slide rail down
2
until it latches into place.
L
svc_bb1ka005
Figure 21. Installing the SAN Volume Controller 2145-CF8 slide rails on the rack
Chapter 2. Installing the SAN Volume Controller 2145-CF8 hardware
25