IBM SAN Volume Controller 2145-CF8, Руководство по установке оборудования

Страница: 52 / 101

4. Install the front of the rail into the front of the rack.
a. Pull the slide rail forward.
b. Insert the two pins on the front of the rail, as shown by
1
in Figure 23,
into the two lower holes in the U on the front of the rack.
c.
Drop the rail into place until it clicks.
d. Push the front latch
2
in all the way.
5. Install the other rail in the same manner.
Installing the cable-management arm for the SAN Volume
Controller 2145-CF8
The SAN Volume Controller 2145-CF8 uses a cable-management arm to route and
secure power and communication cables.
The parts involved in installing the cable-management arm are shown in Figure 20
on page 24.
Install the cable-management arm to pivot from the left side of the SAN Volume
Controller 2145-CF8 rack, when viewed from the rear of the rack.
To attach the arm, perform the following steps:
1.
Pull the node slightly out of the rack to provide space for working on the
cable-management arm at the rear of the rack.
svc_bb1ka010
Figure 22. Installing the rear of a SAN Volume Controller 2145-CF8 slide rail in the rear of
the rack
svc_bb1ka015
Figure 23. Installing the front of a SAN Volume Controller 2145-CF8 slide rail in the front of
the rack
26
IBM System Storage SAN Volume Controller: Model 2145-CF8 Hardware Installation Guide