IBM RackSwitch G8000, Инструкция по применению

Страница: 58 / 362

56
RackSwitch G8000: Application Guide
Configuring SSH/SCP Features on the Switch
SSH and SCP features are disabled by default. To change the SSH/SCP settings,
using the following procedures.
To Enable or Disable the SSH Feature
Begin a Telnet session from the console port and enter the following commands:
To Enable or Disable SCP Apply and Save
Enter the following commands from the switch CLI to enable the SCP
putcfg_apply
and
putcfg_apply_save
commands:
Configuring the SCP Administrator Password
To configure the SCP-only administrator password, enter the following command
(the default password is
admin
):
Using SSH and SCP Client Commands
This section shows the format for using some client commands. The following
examples use 205.178.15.157 as the IP address of a sample switch.
To Log In to the Switch
Syntax:
Note: The
-4
option (the default) specifies that an IPv4 switch address will be
used. The
-6
option specifies IPv6.
Example :
RS G8000(config)# [
no
]
ssh enable
RS G8000(config)# [
no
]
ssh scp-enable
RS G8000(config)# [
no
]
ssh scp-password
Changing SCP-only Administrator password; validation required...
Enter current administrator password:
<password>
Enter new SCP-only administrator password:
<new password>
Re-enter new SCP-only administrator password:
<new password>
New SCP-only administrator password accepted.
>>
ssh
[
-4
|
-6
]
<switch IP address>
-or-
>>
ssh
[
-4
|
-6
]
<login name>
@
<switch IP address>
>>
ssh scpadmin@205.178.15.157