IBM RackSwitch G8000, Инструкция по применению

Страница: 177 / 362

© Copyright IBM Corp. 2011 Chapter 14. VMready
175
VMready Information Displays
The G8000 can be used to display a variety of VMready information.
Note: Some displays depict information collected from scans of a VMware vCenter
and may not be available without a valid vCenter. If a vCenter is assigned
(see “Assigning a vCenter” on page 170 ), scan information might not be
available for up to two minutes after the switch boots or when VMready is
first enabled. Also, any major changes made through the vCenter may take
up to two minutes to be reflected on the switch unless you force an
immediate vCenter scan (see “vCenter Scans” on page 170 .
Local VE Information
A concise list of local VEs and pre-provisioned VEs is available with the following
ISCLI privileged EXEC command:
Note: The Index numbers shown in the VE information displays can be used to
specify a particular VE in configuration commands.
RS G8000#
show virt vm
IP Address VMAC Address Index Port VM Group (Profile)
---------------- ----------------- ----- ------- ------------------
*172.16.46.50 00:50:56:4e:62:00 4 3
*172.16.46.10 00:50:56:4f:f2:00 2 4
+172.16.46.51 00:50:56:72:ec:00 1 3
+172.16.46.11 00:50:56:7c:1c:00 3 4
172.16.46.25 00:50:56:9c:00:00 5 4
172.16.46.15 00:50:56:9c:21:00 0 4
172.16.46.35 00:50:56:9c:29:00 6 3
172.16.46.45 00:50:56:9c:47:00 7 3
Number of entries: 8
* indicates VMware ESX Service Console Interface
+ indicates VMware ESX/ESXi VMKernel or Management Interface