IBM RackSwitch G8000, Инструкция по применению

Страница: 45 / 362

© Copyright IBM Corp. 2011 Chapter 2. Initial Setup
43
Setup Part 5: Final Steps
1. When prompted, decide whether to restart Setup or continue:
Enter
y
to restart the Setup utility from the beginning, or
n
to continue.
2. When prompted, decide whether you wish to review the configuration changes:
Enter
y
to review the changes made during this session of the Setup utility. Enter
n
to continue without reviewing the changes. We recommend that you review the
changes.
3. Next, decide whether to apply the changes at the prompt:
Enter
y
to apply the changes, or
n
to continue without applying. Changes are
normally applied.
4. At the prompt, decide whether to make the changes permanent:
Enter
y
to save the changes to flash. Enter
n
to continue without saving the
changes. Changes are normally saved at this point.
5. If you do not apply or save the changes, the system prompts whether to abort
them:
Enter
y
to discard the changes. Enter
n
to return to the “
Apply the
changes?
” prompt.
Note: After initial configuration is complete, it is recommended that you change the
default passwords.
Would you like to run from top again? [y/n]
Review the changes made? [y/n]
Apply the changes? [y/n]
Save changes to flash? [y/n]
Abort all changes? [y/n]