IBM QS22 - BladeCenter - 0793, Инструкция по установке и эксплуатации

Страница: 68 / 114

The
-u
option performs an unattended and automatic update of the firmware. The
blade server reboots automatically as part of the update process.
Firmware update steps
Complete the following steps to update the firmware automatically:
1. Check the README before attempting to update the system firmware as it
contains specific information about the particular firmware release.
2. Download the update package from http://www.ibm.com/support/us/en/. The
update package has a .sh extension.
3. Change to the directory where you have downloaded the package.
4. Run the package with the -u option. Using the example from above, at the
command prompt enter:
./ brcm_fw_nic_2.0.3-e-1_rhel5_cell.sh -u
During the update process, messages similar to the following appear on the
console:
[root@c4b14 brcm-2.0.3-ppc]# ./ brcm_fw_nic_2.0.3-e-1_rhel5_cell.sh -u
IBM Ethernet Firmware Update Tool, Version 1.0.2
Warning. No Broadcom NetXtreme II adapters found.
ADAPTER MAC BOOT IPMI ASF PXE UMP
------------------- ---- ---- --- --- ---
001A640E030C (5704s) 3.21 2.20 NA NA NA
001A640E030D (5704s) NA NA NA NA NA
Updating Broadcom NetXtreme adapters.
Updating 001A640E030C using file 16A8bc.bin ---> Update successful
Updating 001A640E030C using file 16A8ipmi.bin ---> Update successful
Error! Firmware not detected on device 001A640E030D.
Warning. No Broadcom NetXtreme II adapters found.
ADAPTER MAC BOOT IPMI ASF PXE UMP
------------------- ---- ---- --- --- ---
001A640E030C (5704s) 3.38 2.47 NA NA NA
001A640E030D (5704s) NA NA NA NA NA
One or more errors occurred during the firmware update process. See /var
Note: The error message shown above is correct as it refers to an adapter not
available on QS22.
Blade server Ethernet controller enumeration
The enumeration of the Ethernet controller or controller ports in a blade server is
operating system dependent. You can verify the Ethernet controller or controller port
designations that a blade server uses through your operating system settings.
The routing of an Ethernet controller or controller port to a particular BladeCenter
unit I/O bay depends on the type of Ethernet controller that is installed. You can
verify which Ethernet-controller port is routed to which I/O bay by using the
following test:
1. Install only one Ethernet switch module or pass-thru module, in I/O bay 1.
2. Make sure that the ports on the switch module or pass-thru module are enabled
( Switch Tasks
→
Management
→
Advanced Switch Management in the
BladeCenter Management Module Web interface).
52
BladeCenter QS22 Type 0793: Installation and User’s Guide