IBM QS22 - BladeCenter - 0793, Инструкция по установке и эксплуатации

Страница: 49 / 114

Complete the following steps to install the BladeCenter PCI Express I/O Expansion
Unit:
1. Read the safety information beginning on page vii and “Installation guidelines”
on page 19.
2. Remove the blade server cover and set it aside. See “Opening and removing
the blade server cover” on page 21 for further information.
3. Remove the connector cover or any optional card from the high-speed
connector. Figure 14 on page 26 shows the location of the high-speed
connector.
4. Lower the expansion unit so that the slots at the rear slide down onto the cover
pins at the rear of the blade server, as shown in Figure 23 on page 32.
5. Carefully close the expansion unit as shown in Figure 23 on page 32 until it
clicks into place.
Replacing the battery
IBM has designed this product with your safety in mind. The lithium battery must be
handled correctly to avoid possible danger. If you replace the battery, you must
adhere to the following instructions.
Note: In the U. S., call 1-800-IBM-4333 for information about battery disposal.
If you replace the original lithium battery with a heavy-metal battery or a battery with
heavy-metal components, be aware of the following environmental consideration.
Batteries and accumulators that contain heavy metals must not be disposed of with
normal domestic waste. They will be taken back free of charge by the manufacturer,
distributor, or representative, to be recycled or disposed of in a proper manner.
To order replacement batteries, call 1-800-IBM-SERV within the United States, and
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada,
call your IBM authorized reseller or IBM marketing representative.
Note: After you replace the battery, the blade server is automatically reconfigured.
However, you must reset the system date and time through the operating
system that you installed.
Statement 2:
Chapter 4. Installing and removing replaceable units
33