IBM pseries 655, Руководство по установке

Страница: 164 / 212

1 Floor Eyebolt 9 Jam Nut 17 Weight Distribution Plate
2 Pin 10 Plastic Bushing 18 Washer
3 Spacer 11 Washer 19 - 20 Nut
4 Toggle Block 12 Frame 21 Turnbuckle Jaw
5 Rubber Bushing 13 Threaded Rod 22 Shaft
6 Raised Floor 14 Nut 23 Floor
7 Plastic Bushing 15 Thick Washer
8 Leveler 16 Spacer
Notes:
a. The four eyebolts required in the installation is supplied and installed in the concrete floor by the
customer.
b. The difference between the turnbuckle assemblies for the low-raised floor and the high-raised
floor is the length of the turnbuckle:
v
The short turnbuckle assembly (part number 11P4755) is used for a 24.13 cm (9-1/2 in.) to
29.8 cm (11-3/4 in.) raised floor.
v
The long turnbuckle assembly (part number 11P4756) is used for a 29.8 cm (11-3/4 in.) to 40.6
cm (16 in.) raised floor.
3. Place the spacer inside the floor eyebolt, and position the floor eyebolt between the lower jaw of the
toggle block.
4. Install the shaft, nut and pin (if applicable), and spacer.
5. Turn the toggle block until the tip of lower jaw is approximately 2.54 cm (1 in.) inside the toggle block.
6. Remove threaded rod, rubber bushing, plastic housing and washers from the turnbuckle assembly.
7. Install the floor tile and place the stabilizer plate on the floor tile.
8. Line up the holes in the floor tiles with the holes in the stabilizer bar.
9. Move the system frame so that the frame leveler is located over the prepared floor tiles holes.
148
Eserver
pSeries 655 Installation Guide