IBM Power System PCIe3, Руководство пользователя

Страница: 21 / 66

b. Turn the quarter-turn fasteners (B) to engage and lock the bracket into position.
Preparing the EMX0 PCIe3 expansion drawer for operation after you
install a PCIe3 6-slot fanout module
To prepare the EMX0 PCIe3 expansion drawer for operation after you install a PCIe3 6-slot fanout
module, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Choose from the following options:
v If you do not plan to immediately connect the EMX0 PCIe3 expansion drawer to a server, continue
with 3.
v
If you plan to connect the EMX0 PCIe3 expansion drawer to a server, you need to ensure that you
have the PCIe3 cable adapter installed in your server and then connect the server to your EMX0
PCIe3 expansion drawer. For instructions, see:
– Installing a PCIe adapter(http://www.ibm.com/support/knowledgecenter/POWER9/p9hak/
pciadapters.htm) and select the appropriate model
– Connecting an EMX0 PCIe3 expansion drawer to your system(http://www.ibm.com/support/
knowledgecenter/POWER9/p9egp/p9egp_connect_kickoff.htm)
3. Put the cable management bracket in the operating position. See Figure 6 on page 6.
a. Pull out the quarter-turn fasteners (B) and turn them to disengage them while moving the cable
management bracket (A) to its lower position.
b. Turn the quarter-turn fasteners (B) to engage and lock the bracket into position.
Figure 5. Placing the cable management bracket in the lowered operating position
PCIe3 6-slot fanout module
5