IBM PC 300GL Types 6275, Руководство пользователя

Страница: 106 / 176

POST
Message Description
162 A change in device configuration occurred. This message
displays under one or more of the following conditions:
Ÿ
A new device has been installed.
Ÿ
A device has been moved to a different location or cable
connection.
Ÿ
A device has been removed or disconnected from a cable.
Ÿ
A device is failing and is no longer recognized by the
computer.
Ÿ
An external device is not turned on.
Ÿ
Processor update code has not been installed or cannot be
found.
Ÿ
The Erasing Lost or Forgotten Passwords procedure was
performed. This also erases configuration data.
Ÿ
An invalid checksum is detected in CMOS memory
(nonvolatile RAM).
Action:
1. Verify that all external devices are turned on. External
devices must be turned on before the computer is turned on.
2. Verify that all devices are properly installed and securely
connected.
3. If you added, removed, or changed the location of a device,
or you erased passwords, you must save the new
configuration before exiting from the Configuration/Setup
Utility Program.
4. If you added or changed a microprocessor, you must update
system programs. See “Updating System Programs” on
page 24 for instructions.
5. If you did not add, remove, or change the location of a
device, the device is probably failing. Running the
diagnostic programs might isolate the failing device. See
“IBM Enhanced Diagnostics” on page 118 for more
information.
If the problem cannot be corrected, have the computer serviced.
163 The clock is not working correctly.
Action: Set the correct date and time. If the date and time are
set correctly and saved and the message reappears, replace the
battery.
If this does not correct the problem, have the computer serviced.
Note: The computer can be used until it is serviced, but any
application programs that use the date and time will be
affected.
92
PC 300GL User Guide